 |
 |
 |
|
Step 1: |
 |
|
Spread the diffusing screen on a table screen back facing up
and put the speed ring inside the screen.
|
|
|
|
Step 2: |
 |
Take one black wand and insert the tipped end into one hole of
the speed ring and insert the other end of the black wand into
the near corner of the screen.
|
|
|
|
Step 3: |
 |
|
Insert the second and third wands the same as in step #2 with
these wands being 90 degrees from each other in the speed
ring to form 3/4 of a square.
|
|
|
|
Step 4: |
 |
|
Take the fourth and final wand, and insert it into the last
remaining corner of the screen. Use one hand to hold the speed
ring while using the other hand on the wand to slightly bend the
wand with strength from your wrist. The slight bend in the
wand should go out into the screen as the other wands are.
Insert the end of the wand into the hole in the speed ring.
|
|
|
|
Step 5: |
 |
Turn the softbox upside down and close the four flaps with the
Velcro patches.
|
|
|
|
Step 6: |
 |
Mount the assembled frame to the light head by lining up the
three tabs and turning into place. Then, after rotating the frame
to the desired angle, insert the bulb in the light and stretch the
front panel over the softbox securing with velcro tabs.
|
